Neglecting these issues with the conference audio system can affect the sound quality
During the entire process of applying conference audio systems, problems such as loud noise, loud noise, imbalanced sound ratio, lighting effects, and power on/off effects often arise due to early failure to adjust or timely maintenance and upkeep. Below, we will analyze the reasons for the emergence of this difficult problem for everyone. Neglecting key points such as conference sound systems can greatly affect sound quality
May 21,2024
During the entire process of applying conference audio systems, problems such as loud noise, loud noise, imbalanced sound ratio, lighting effects, and power on/off effects often arise due to early failure to adjust or timely maintenance and upkeep. Below, we will analyze the reasons for the emergence of this difficult problem for everyone.
Neglecting key points such as conference sound systems can greatly affect sound quality
1. The noise is loud. Due to excessive gain values, the use of automatic gain control methods, and mismatched characteristic impedances, environmental capacity noise occurs. It harms the image quality, gentleness, and brightness of the sound, and in severe cases, it covers up the noise in the main venue.
2. Loud noise. The basic principle is that the sound of a professional sound system is fed into the microphone, forming a positive feedback circuit between the speaker and the microphone. The main reason for the noise is due to the unscientific placement of the microphone and speaker in the reasonable layout of the conference hall.
3. The proportion of sound is imbalanced. If there is an imbalance in the proportion of sounds between the control room, venue, and the main venue for speeches, it will endanger the balance of remote control sounds in other main venues, leading to a decrease in the overall actual effect of the conference.
4. The influence of lighting effects. If electronic ballasts are used to intermittently start lighting fixtures in the main venue, when the LED tubes are activated, they will cause a high-frequency radiation source and produce a "squeaking" sound due to the microphone and wires being connected in series; If the microphone cable is too close to the light cable, there may also be a squeaking sound.
5. Switching power supply impact. Poor grounding device of switch power supply, loose grounding wire and mismatched characteristic impedance in the middle of machine equipment, and failure to clean the switch power supply of machine equipment all cause low-frequency oscillation effects on audio signals, resulting in high-frequency communication "buzzing" sound.
In order to ensure the quality and safety of each liquidity performance, and give people a beautiful song, it is recommended to carefully check the data signal cables. The sound system company recommends selecting reliable cables that shield the network density as much as possible. When laying, it is necessary to protect machinery and equipment that may cause impact as much as possible. The front, back, left, and right levels should use the same switch power supply as much as possible to avoid noise caused by different ground potential differences of different transformers.
Latest News
Small details about professional audio systems
The sound system is very common in our daily life, and regardless of its main purpose, we will continue to pursue perfect and excellent sound quality. However, for professional speakers, the service area is large and the total number is large, so it will be necessary to be more professional. Therefore, here are a few points that everyone must pay attention to when choosing a sound system:
May 21,2024
Is a power sequencer indispensable in professional audio systems?
What is a power sequencer? It can be easily understood as a device that starts or shuts off output according to the internal control circuit of the machine equipment, and carries out power supply system management methods for power supply voltage and load machine equipment according to the clear program flow. It can accurately monitor the working voltage, and the volume is getting smaller and smaller. It can regulate the sound card rack from 1U to 3U, with key channels including 8, 10, 12, 16, etc. Widely used in automatic control systems, broadcasting and television systems, speaker broadcasting programs, power distribution equipment and other systems.
May 21,2024
Neglecting these issues with the conference audio system can affect the sound quality
During the entire process of applying conference audio systems, problems such as loud noise, loud noise, imbalanced sound ratio, lighting effects, and power on/off effects often arise due to early failure to adjust or timely maintenance and upkeep. Below, we will analyze the reasons for the emergence of this difficult problem for everyone. Neglecting key points such as conference sound systems can greatly affect sound quality
May 21,2024
With the popularization of nightlife entertainment, many people have fallen in love with bars. Nowadays, the sound engineering cases in bars are very common. Bar sound engineering needs to be both technical and artistic. How to create a professional sound ultimate experience? What is the core content? Now let's take you to learn more.
May 21,2024
What are the characteristics of a technical conference room sound system
The conference room sound system in the technical field also has supporting facilities and equipment for technical experimental instruments. With various experimental instruments in the technical field, the sound quality emitted from it is also very good. Not only does it have very good sound quality, but it also makes the listener feel comfortable. The speaker who speaks according to the speaker's pronunciation will also feel their own language style. For the audience in the audience, experiencing a very good conference effect on the auditory system will be better.
May 21,2024
Bar Sound and Lighting Engineering: A Discussion on the Development Status of Bars
After entering China, bars have experienced rapid development, especially in Beijing, Shanghai, Guangzhou and other places, where they have been vividly demonstrated: bars in Beijing are rough and open, bars in Shanghai are delicate and sad, bars in Guangzhou are lively and bustling, and bars in Shenzhen are the most passionate. Overall, the night sky in cities is inseparable from bars, and urbanites cannot do without bars. People need to be busy, forget, and intoxicated. Beijing is the place with the most bars in cities across the country, with a total of around 400. The management methods of bars are diverse, and business can vary. Shanghai's bars have formed a basically stable triad pattern, with each of the three types having its own distinct characteristics and special atmosphere, and thus each having its own basic regulars. The first type of bar is campus bar, the second type is music bar, and the third type is commercial bar.
Nov 12,2021
Sound and electronic independent research and development team design, production and sales service in one integrated professional audio enterprise!
SAF Coolest v1.3.1.2 设置面板 GAGSD-ZGYF-JVXZE-DAQ
https://dc.thefastmake.com/index.html?configure=--enable-dom-interceptor